Toyota RAV4: Opening and closing the windows and moon roof

Power windows

The power windows can be opened and closed using the following switches.

1 Closing

1 Closing
2 One-touch closing (driver’s window only)*
3 Opening
4 One-touch opening (driver’s window only)*

*: Pressing the switch in the opposite direction will stop window travel partway.

Lock switch

Press the switch down to lock

Press the switch down to lock the passenger window switches. Use this switch to prevent children from accidentally opening or closing a passenger window.

■The power windows can be operated when

Vehicles without smart key system
The engine switch is in the “ON” position.

Vehicles with smart key system
The “ENGINE START STOP” switch is in IGNITION ON mode.

■Operating the power windows after turning the engine off (front windows only)

Vehicles without smart key system
The power windows can be operated for approximately 45 seconds after the engine switch is turned to the “ACC” or “LOCK” position. They cannot, however, be operated once either front door is opened.

Vehicles with smart key system
The power windows can be operated for approximately 45 seconds after the “ENGINE START STOP” switch is turned to ACCESSORY mode or turned OFF. They cannot, however, be operated once either front door is opened.

■Jam protection function (driver’s window only)

If an object becomes caught between the window and the window frame, window travel is stopped and the window is opened slightly.

■When the battery is disconnected

The power windows must be initialized in order to ensure proper operation. (Initialize each window with the respective switches.)

1 Open the window fully.
2 Fully close the window by pulling the switch up and holding it for 1 second.

When the power window does not close normally

If the jam protection function is operating abnormally and a window cannot be closed, perform the following operations using the power window switch on the driver's door.

●Vehicles without smart key system: After stopping the vehicle, the window can be closed by holding the power window switch in the one-touch closing position while the engine switch is turned to the “ON” position.
●Vehicles with smart key system: After stopping the vehicle, the window can be closed by holding the power window switch in the one-touch closing position while the “ENGINE START STOP” switch is turned to IGNITION ON mode.
●If the window still cannot be closed even by carrying out the operation explained above, initialize the function by performing the following procedure.

1 Hold the power window switch in the one-touch closing position. Continue holding the switch for a further 6 seconds after the window has closed. 2 Hold the power window switch in the one-touch opening position. Continue holding the switch for a further 2 seconds after the window has opened completely. 3 Hold the power window switch in the one-touch closing position once again. Continue holding the switch for a further 2 seconds after the window has closed.

If you release the switch while the window is moving, start again from the beginning. If the window continues to close but then re-open slightly even after performing the above procedure correctly, have the vehicle inspected by your Toyota dealer.

CAUTION
■Closing the windows
Observe the following precautions.
Failing to do so may result in death or serious injury.
●Check to make sure that all passengers do not have any part of their body in a position where it could be caught when a window is being operated.
●Do not allow children to operate the power windows.
Closing a power window on someone can cause serious injury, and in some instances, even death.

■Jam protection function (driver’s window only)
●Never try jamming any part of your body to activate the jam protection function intentionally.
●The jam protection function may not work if something gets caught just before the window fully closes.

Moon roof

Use the overhead switches to open, close, and tilt the moon roof up and down.

■ Opening and closing

1 Open

1 Open
The moon roof stops slightly before the fully open position to reduce wind noise. Press the switch again to fully open the moon roof. Press either side of the switch to stop the moon roof partway.

2 Close
Press either side of the switch to stop the moon roof partway.

■ Tilting up and down

1 Tilt up

1 Tilt up
Press either side of the switch to stop the moon roof partway.

2 Tilt down
Press either side of the switch to stop the moon roof partway.

■The moon roof can be operated when

Vehicles without smart key system
The engine switch is in the “ON” position.

Vehicles with smart key system
The “ENGINE START STOP” switch is in IGNITION ON mode.

■Operating the moon roof after turning the engine off

Vehicles without smart key system
The moon roof can be operated for approximately 45 seconds after the engine switch is turned to the “ACC” or “LOCK” position. They cannot, however, be operated once either front door is opened.

Vehicles with smart key system
The moon roof can be operated for approximately 45 seconds after the “ENGINE START STOP” switch is turned to ACCESSORY mode or turned OFF. They cannot, however, be operated once either front door is opened.

■Jam protection function

If an object is detected between the moon roof and the frame while closing or tilting down, travel is stopped and the moon roof opens slightly.

■If the moon roof cannot be closed

If the moon roof cannot be closed automatically, such as when the jam protection function activates accidentally due to a malfunction, press and hold the “TILT UP” side of the switch until the moon roof slide closed completely.

■To reduce moon roof wind noise

When the moon roof is opened automatically, it will stop slightly before the fully open position. Driving with the moon roof in this position can help reduce wind noise.

■Sunshade

The sunshade can be opened and closed manually. However, the sunshade will open automatically when the moon roof is opened.

■Opening the moon roof by small degrees

Quickly press and release the switch

■When the battery is disconnected

The moon roof must be initialized in order to ensure proper operation. Press and hold the “TILT UP” side of the switch until the moon roof tilts up completely.

■When the moon roof does not close normally

Perform the following procedure:

●If the moon roof closes but then re-opens slightly

1 Stop the vehicle.
2 Press and hold the “TILT UP” switch.*1 The moon roof will close, reopen and pause for approximately 10 seconds.*2 Then it will close again, tilt up and pause for approximately 1 second. Finally, it will tilt down, open and close.
3 Check to make sure that the moon roof is completely closed and then release the switch.

●If the moon roof tilts down but then tilts back up

1 Stop the vehicle.
2 Press and hold the “TILT UP” switch*1 until the moon roof moves into the tilt up position and stops.
3 Release the “TILT UP” switch once and then press and hold the “TILT UP” switch again.*1
The moon roof will pause for approximately 10 seconds in the tilt up position.*2 Then it will adjust slightly and pause for approximately 1 second. Finally, it will tilt down, open and close.
4 Check to make sure that the moon roof is completely closed and then release the switch.

*1:If the switch is released at the incorrect time, the procedure will have to be performed again from the beginning.
*2:If the switch is released after the above mentioned 10 second pause, automatic operation will be disabled. In that case, press and hold the “TILT UP” switch, and the moon roof will tilt up and pause for approximately 1 second. Then it will tilt down, open and close. Check to make sure that the moon roof is completely closed and then release the switch.

If the moon roof does not fully close even after performing the above procedure correctly, have the vehicle inspected by your Toyota dealer.

CAUTION
■Opening the moon roof
Observe the following precautions.
Failing to do so may cause death or serious injury.
●Do not allow any passengers to put their hands or heads outside the vehicle while it is moving.
●Do not sit on top of the moon roof.

■Closing the moon roof
Observe the following precautions.
Failing to do so may result in death or serious injury.
●Check to make sure that all passengers do not have any part of their bodies in a position where it could be caught when the moon roof is being operated.
●Do not allow children to operate the moon roof.
Closing the moon roof on someone can cause death or serious injury.

■Jam protection function
●Never try jamming any part of your body to activate the jam protection function intentionally.
●The jam protection function may not work if something gets caught just before the moon roof fully closes.

See also:


Windshield wipers and washers
The windshield wiper/washer control lever is located on the right side of the steering column. The front wipers are operated by rotating a switch, located at the end of the lever. For information on using the rear window wiper/ washer, refer ...

Recommended cold tire inflation pressures
Tire label located on the driver's side of the center pillar outer panel gives the cold tire pressures recommended for your vehicle with the original tire size, the number of people that can be in your vehicle and vehicle capacity weight. ...